Due to adverts being cached, kindly refer to our website for current and up to date pricing
Google Lantis Electronics
Head Shell S-ARM type for turntable tone arm,
A head-shell is a head piece designed to be attached to the end of a turntable’s or record player,‘s “tone arm” and the cartridge is bolted to it.Normally, by using a couple of 2.5 mm bolts, it’s possible to fit all standard cartridges with 1/2’’ (about 12,5 mm) mount.
The color code below applies to the majority of turntables and tone arms - this code is applicable to the pins on the rear of the turntable cartridge:
Left = white wire
Left Ground = blue wire
Right = red wire
Right Ground = green wire
Be certain to check your turntable user guide to confirm the colors above.
For a removable head-shell, the “typical” wiring is as follows - viewed from the wire side of the head-shell connector:
Upper left = white
Upper right = red
Lower left = blue
Lower right = green
Again, this may vary depending on the model and make of the turntable
Our head shells are already equipped with their respective wires for connection to the cartridge.
Back To Top